Manufacturers / Titleist / GT1 Driver / Compatible shafts
Sleeve fitTitleist GT1 Driver compatible shafts
The GT1 Driver uses the Titleist SureFit Hosel adapter (Titleist connector system), SureFit (910 through GTS, 2011 to present) (0.335" tip).
Check your shaft
Type the model your shaft is currently in (or was pulled from) to see whether it fits the GT1 Driver.
Drops straight in
Both use the , " tip. No reshaft, no builder. Re-check your loft position after the swap.
Fits, after an adapter swap
Not a drop-in. This shaft carries a ; the GT1 Driver needs a . The shaft itself works: a club builder swaps the adapter for a small shop fee.
The shaft's " tip differs from this head's " tip, so the builder may need to re-tip it; it may not be a clean swap.
Does not fit
Fits, after an adapter install
That shaft has no adapter, it is glued into a fixed hosel. A club builder can cut it and install a adapter to make it fit this head.
Fit unknown
We have not verified that model's hosel hardware yet, so we cannot say whether its shaft carries an adapter or is glued in. Treat this combination as unknown rather than assuming a fit.
Not in our catalog
That model is not in our catalog yet. Report it so we can add it, rather than guess.
Sleeve interchange
Researched cases where a sleeve from another generation of this same brand does or does not fit this head.
| Sleeve family | Verdict | Notes | Source |
|---|---|---|---|
| Titleist SureFit Fairway Hosel | Does not fit | GT1's factory SureFit driver sleeve is presumed a different part than the Fairway SureFit sleeve, consistent with the rest of the GT/TSR/TSi/TS family; no vendor names GT1 yet. | Inferred from aftermarket sleeve part coverage, cross-checked across suppliers. |
Shafts that drop in from another head
A shaft pulled from any of these heads carries a sleeve the GT1 Driver accepts, so it drops straight in, no reshaft.
- Titleist GT2 Driver
- Titleist GT3 Driver
- Titleist GT4 Driver
- Titleist GTS2 Driver
- Titleist GTS3 Driver
- Titleist GTS4 Driver
- Titleist TS1 Driver
- Titleist TS2 Driver
- Titleist TS3 Driver
- Titleist TS4 Driver
- Titleist TSi1 Driver
- Titleist TSi2 Driver
- Titleist TSi3 Driver
- Titleist TSi4 Driver
- Titleist TSR1 Driver
- Titleist TSR2 Driver
- Titleist TSR3 Driver
- Titleist TSR4 Driver
Stock shaft
Any 0.335 inch tip shaft can be built for this hosel by a club builder; the sleeve, not the shaft model, is what decides whether a used pull drops in.
Shafts from other brands
Sleeve adapters are brand specific. A shaft pulled from a different brand's head carries that brand's sleeve, not this one, so it needs the sleeve swapped by a club builder before it fits this head.
Fit from Titleist SureFit Tour Performance Manual (915/913/910 and 816 Performance Fitting Guide).
Adapter settings chart: what every position does
Thanks. We verify every report against a source before updating the data.
Something went wrong with that report. Please try again.