Manufacturers / Titleist / TSR2+ Fairway / Compatible shafts
Sleeve fitTitleist TSR2+ Fairway compatible shafts
The TSR2+ Fairway uses the Titleist SureFit Fairway Hosel adapter (Titleist connector system), SureFit Fairway Hosel (fairway woods 2019 to present, and GT280/GTS300 mini drivers, in this catalog) (0.335" tip).
Check your shaft
Type the model your shaft is currently in (or was pulled from) to see whether it fits the TSR2+ Fairway.
Drops straight in
Both use the , " tip. No reshaft, no builder. Re-check your loft position after the swap.
Fits, after an adapter swap
Not a drop-in. This shaft carries a ; the TSR2+ Fairway needs a . The shaft itself works: a club builder swaps the adapter for a small shop fee.
The shaft's " tip differs from this head's " tip, so the builder may need to re-tip it; it may not be a clean swap.
Does not fit
Fits, after an adapter install
That shaft has no adapter, it is glued into a fixed hosel. A club builder can cut it and install a adapter to make it fit this head.
Fit unknown
We have not verified that model's hosel hardware yet, so we cannot say whether its shaft carries an adapter or is glued in. Treat this combination as unknown rather than assuming a fit.
Not in our catalog
That model is not in our catalog yet. Report it so we can add it, rather than guess.
Sleeve interchange
Researched cases where a sleeve from another generation of this same brand does or does not fit this head.
| Sleeve family | Verdict | Notes | Source |
|---|---|---|---|
| Titleist SureFit Hosel | Does not fit | This fairway wood's Fairway SureFit sleeve is a different part than the driver SureFit Hosel. | Inferred from aftermarket sleeve part coverage, cross-checked across suppliers. |
Shafts that drop in from another head
A shaft pulled from any of these heads carries a sleeve the TSR2+ Fairway accepts, so it drops straight in, no reshaft.
- Titleist GT1 Fairway
- Titleist GT2 Fairway
- Titleist GT280 Mini Driver
- Titleist GT3 Fairway
- Titleist GTS300 Mini Driver
- Titleist TS2 Fairway
- Titleist TS3 Fairway
- Titleist TSi1 Fairway
- Titleist TSi2 Fairway
- Titleist TSi3 Fairway
- Titleist TSR1 Fairway
- Titleist TSR2 Fairway
- Titleist TSR2+ Fairway
- Titleist TSR3 Fairway
Stock shaft
Any 0.335 inch tip shaft can be built for this hosel by a club builder; the sleeve, not the shaft model, is what decides whether a used pull drops in.
Shafts from other brands
Sleeve adapters are brand specific. A shaft pulled from a different brand's head carries that brand's sleeve, not this one, so it needs the sleeve swapped by a club builder before it fits this head.
Fit from Titleist Newsroom: Titleist Introduces New GT280 Mini Driver.
Adapter settings chart: what every position does
Thanks. We verify every report against a source before updating the data.
Something went wrong with that report. Please try again.