Manufacturers / PING / G400 Max Driver / Compatible shafts
Sleeve fitPING G400 Max Driver compatible shafts
The G400 Max Driver uses the PING G400 Adjustable Hosel adapter (Ping connector system), G400 adjustable hosel (5-position loft/lie, +/-1.0 deg) (0.335" tip).
Check your shaft
Type the model your shaft is currently in (or was pulled from) to see whether it fits the G400 Max Driver.
Drops straight in
Both use the , " tip. No reshaft, no builder. Re-check your loft position after the swap.
Fits, after an adapter swap
Not a drop-in. This shaft carries a ; the G400 Max Driver needs a . The shaft itself works: a club builder swaps the adapter for a small shop fee.
The shaft's " tip differs from this head's " tip, so the builder may need to re-tip it; it may not be a clean swap.
Does not fit
Fits, after an adapter install
That shaft has no adapter, it is glued into a fixed hosel. A club builder can cut it and install a adapter to make it fit this head.
Fit unknown
We have not verified that model's hosel hardware yet, so we cannot say whether its shaft carries an adapter or is glued in. Treat this combination as unknown rather than assuming a fit.
Not in our catalog
That model is not in our catalog yet. Report it so we can add it, rather than guess.
Sleeve interchange
Researched cases where a sleeve from another generation of this same brand does or does not fit this head.
| Sleeve family | Verdict | Notes | Source |
|---|---|---|---|
| Ping Trajectory Tuning family | Does not fit | Ping's G400-generation hosel is a physically distinct sleeve from the G410-through-G440 Trajectory Tuning family; it does not interchange with this model's factory adapter generation. | Inferred from aftermarket sleeve part coverage, cross-checked across suppliers. |
Shafts that drop in from another head
No other head in this catalog shares this sleeve.
Ping's G410-and-later Trajectory Tuning sleeve does not fit G400-generation heads; G400 uses its own adapter, shared only with the earlier G and G30 generations.
Stock shaft
Any 0.335 inch tip shaft can be built for this hosel by a club builder; the sleeve, not the shaft model, is what decides whether a used pull drops in.
Shafts from other brands
Sleeve adapters are brand specific. A shaft pulled from a different brand's head carries that brand's sleeve, not this one, so it needs the sleeve swapped by a club builder before it fits this head.
Fit from PING G400 Driver Product Page.
Thanks. We verify every report against a source before updating the data.
Something went wrong with that report. Please try again.