Manufacturers / Mizuno / ST200X Fairway / Compatible shafts
Sleeve fitMizuno ST200X Fairway compatible shafts
The ST200X Fairway uses the Mizuno Quick Switch Fairway adapter (Mizuno connector system), Quick Switch Fairway (GT180/ST180 2018 through JPX One 2026) (0.335" tip).
Check your shaft
Type the model your shaft is currently in (or was pulled from) to see whether it fits the ST200X Fairway.
Drops straight in
Both use the , " tip. No reshaft, no builder. Re-check your loft position after the swap.
Fits, after an adapter swap
Not a drop-in. This shaft carries a ; the ST200X Fairway needs a . The shaft itself works: a club builder swaps the adapter for a small shop fee.
The shaft's " tip differs from this head's " tip, so the builder may need to re-tip it; it may not be a clean swap.
Does not fit
Fits, after an adapter install
That shaft has no adapter, it is glued into a fixed hosel. A club builder can cut it and install a adapter to make it fit this head.
Fit unknown
We have not verified that model's hosel hardware yet, so we cannot say whether its shaft carries an adapter or is glued in. Treat this combination as unknown rather than assuming a fit.
Not in our catalog
That model is not in our catalog yet. Report it so we can add it, rather than guess.
Sleeve interchange
Researched cases where a sleeve from another generation of this same brand does or does not fit this head.
| Sleeve family | Verdict | Notes | Source |
|---|---|---|---|
| Mizuno Quick Switch family | Does not fit | This fairway wood's Quick Switch FAIRWAY sleeve is a different part than the Quick Switch DRIVER sleeve. | Inferred from aftermarket sleeve part coverage, cross-checked across suppliers. |
Shafts that drop in from another head
A shaft pulled from any of these heads carries a sleeve the ST200X Fairway accepts, so it drops straight in, no reshaft.
- Mizuno GT180 Fairway
- Mizuno JPX One Fairway
- Mizuno JPX One Tour Spoon Fairway
- Mizuno ST-G Titanium Fairway
- Mizuno ST-MAX 230 Fairway
- Mizuno ST-X 220 Fairway
- Mizuno ST-Z 230 Fairway
- Mizuno ST-Z Fairway
- Mizuno ST180 Fairway
- Mizuno ST190 Fairway
- Mizuno ST190 TS Fairway
- Mizuno ST200 Fairway
- Mizuno ST200 Tour Spoon Fairway
Any 0.335 inch tip shaft can be built for this hosel by a club builder; the sleeve, not the shaft model, is what decides whether a used pull drops in.
Shafts from other brands
Sleeve adapters are brand specific. A shaft pulled from a different brand's head carries that brand's sleeve, not this one, so it needs the sleeve swapped by a club builder before it fits this head.
Fit from Mizuno ST-Z Fairway Adaptability Chart (3W/5W).
Adapter settings chart: what every position does
Thanks. We verify every report against a source before updating the data.
Something went wrong with that report. Please try again.