Manufacturers / Cobra / Aerojet Driver / Compatible shafts
Sleeve fitCobra Aerojet Driver compatible shafts
The Aerojet Driver uses the Cobra MyFly8 (with SmartPad) adapter (Cobra connector system), MyFly8 with SmartPad (King F8 to Darkspeed, 2018 to 2024) (0.335" tip).
Check your shaft
Type the model your shaft is currently in (or was pulled from) to see whether it fits the Aerojet Driver.
Drops straight in
Both use the , " tip. No reshaft, no builder. Re-check your loft position after the swap.
Fits, after an adapter swap
Not a drop-in. This shaft carries a ; the Aerojet Driver needs a . The shaft itself works: a club builder swaps the adapter for a small shop fee.
The shaft's " tip differs from this head's " tip, so the builder may need to re-tip it; it may not be a clean swap.
Does not fit
Fits, after an adapter install
That shaft has no adapter, it is glued into a fixed hosel. A club builder can cut it and install a adapter to make it fit this head.
Fit unknown
We have not verified that model's hosel hardware yet, so we cannot say whether its shaft carries an adapter or is glued in. Treat this combination as unknown rather than assuming a fit.
Not in our catalog
That model is not in our catalog yet. Report it so we can add it, rather than guess.
Sleeve interchange
Researched cases where a sleeve from another generation of this same brand does or does not fit this head.
| Sleeve family | Verdict | Notes | Source |
|---|---|---|---|
| Cobra FutureFit33 | Does not fit | MyFly8-era factory sleeve does not accept, and is not accepted by, a FutureFit33 (DS-Adapt/OPTM) head. | Inferred from aftermarket sleeve part coverage, cross-checked across suppliers. |
Shafts that drop in from another head
A shaft pulled from any of these heads carries a sleeve the Aerojet Driver accepts, so it drops straight in, no reshaft.
- Cobra Aerojet Fairway
- Cobra Aerojet LS Driver
- Cobra Aerojet LS Fairway
- Cobra Aerojet Max Driver
- Cobra Aerojet Max Fairway
- Cobra Darkspeed LS Driver
- Cobra Darkspeed LS Fairway
- Cobra Darkspeed Max Driver
- Cobra Darkspeed Max Fairway
- Cobra Darkspeed X Driver
- Cobra Darkspeed X Fairway
- Cobra King F8 Driver
- Cobra King F8 Fairway
- Cobra King F8+ Driver
- Cobra King F8+ Fairway
- Cobra King F9 Speedback Driver
- Cobra King F9 Speedback Fairway
- Cobra King F9 Speedback Tour Fairway
- Cobra LTDx Driver
- Cobra LTDx Fairway
- Cobra LTDx LS Driver
- Cobra LTDx LS Fairway
- Cobra LTDx Max Driver
- Cobra LTDx Max Fairway
- Cobra RadSpeed Big Tour Fairway
- Cobra RadSpeed Draw Fairway
- Cobra RadSpeed Driver
- Cobra RadSpeed Fairway
- Cobra RadSpeed Tour Fairway
- Cobra RadSpeed XB Driver
- Cobra RadSpeed XD Driver
- Cobra SpeedZone Big Tour Fairway
- Cobra SpeedZone Driver
- Cobra SpeedZone Fairway
- Cobra SpeedZone Tour Fairway
- Cobra SpeedZone Xtreme Driver
Stock shaft
Any 0.335 inch tip shaft can be built for this hosel by a club builder; the sleeve, not the shaft model, is what decides whether a used pull drops in.
Shafts from other brands
Sleeve adapters are brand specific. A shaft pulled from a different brand's head carries that brand's sleeve, not this one, so it needs the sleeve swapped by a club builder before it fits this head.
Inferred from aftermarket sleeve part coverage, cross-checked across suppliers.
Adapter settings chart: what every position does
Thanks. We verify every report against a source before updating the data.
Something went wrong with that report. Please try again.