Manufacturers / Wilson / DYNAPWR LS Driver / Compatible shafts
Sleeve fitWilson DYNAPWR LS Driver compatible shafts
The DYNAPWR LS Driver uses the Wilson Dynapower One-Click Hosel adapter (Wilson connector system), Dynamic Six-Way One-Click Hosel Adapter (Dynapower/Dynapower Carbon 2023 through DYNAPWR/DYNAPWR LS/DYNAPWR Max 2025) (0.335" tip).
Check your shaft
Type the model your shaft is currently in (or was pulled from) to see whether it fits the DYNAPWR LS Driver.
Drops straight in
Both use the , " tip. No reshaft, no builder. Re-check your loft position after the swap.
Fits, after an adapter swap
Not a drop-in. This shaft carries a ; the DYNAPWR LS Driver needs a . The shaft itself works: a club builder swaps the adapter for a small shop fee.
The shaft's " tip differs from this head's " tip, so the builder may need to re-tip it; it may not be a clean swap.
Does not fit
Fits, after an adapter install
That shaft has no adapter, it is glued into a fixed hosel. A club builder can cut it and install a adapter to make it fit this head.
Fit unknown
We have not verified that model's hosel hardware yet, so we cannot say whether its shaft carries an adapter or is glued in. Treat this combination as unknown rather than assuming a fit.
Not in our catalog
That model is not in our catalog yet. Report it so we can add it, rather than guess.
Sleeve interchange
Researched cases where a sleeve from another generation of this same brand does or does not fit this head.
| Sleeve family | Verdict | Notes | Source |
|---|---|---|---|
| Wilson Fast Fit Technology Hosel | Does not fit | DYNAPWR LS (2025) continues the Dynamic Six-Way One-Click Hosel Adapter; Cortex's Fast Fit hosel remains a physically distinct, older part. | Inferred from aftermarket sleeve part coverage, cross-checked across suppliers. |
Shafts that drop in from another head
A shaft pulled from any of these heads carries a sleeve the DYNAPWR LS Driver accepts, so it drops straight in, no reshaft.
- Wilson Dynapower Carbon Driver
- Wilson Dynapower Driver
- Wilson DYNAPWR Carbon Driver
- Wilson DYNAPWR Carbon Fairway
- Wilson DYNAPWR Max Driver
- Wilson DYNAPWR Max+ Driver
Stock shaft
Any 0.335 inch tip shaft can be built for this hosel by a club builder; the sleeve, not the shaft model, is what decides whether a used pull drops in.
Shafts from other brands
Sleeve adapters are brand specific. A shaft pulled from a different brand's head carries that brand's sleeve, not this one, so it needs the sleeve swapped by a club builder before it fits this head.
Fit from Wilson Dynapower Driver Fitting Guide.
Adapter settings chart: what every position does
Thanks. We verify every report against a source before updating the data.
Something went wrong with that report. Please try again.