Manufacturers / Tour Edge / Exotics E725 Fairway / Compatible shafts
Sleeve fitTour Edge Exotics E725 Fairway compatible shafts
The Exotics E725 Fairway uses the Tour Edge Exotics Flight Tuning System Fairway Adapter adapter (Tour Edge connector system), C722/C723/C725/E725/LS fairway adjustable hosel (+/-1.5 deg loft typical, 3 deg lie range on the C723 review), 2022-2026 (0.335" tip).
Check your shaft
Type the model your shaft is currently in (or was pulled from) to see whether it fits the Exotics E725 Fairway.
Drops straight in
Both use the , " tip. No reshaft, no builder. Re-check your loft position after the swap.
Fits, after an adapter swap
Not a drop-in. This shaft carries a ; the Exotics E725 Fairway needs a . The shaft itself works: a club builder swaps the adapter for a small shop fee.
The shaft's " tip differs from this head's " tip, so the builder may need to re-tip it; it may not be a clean swap.
Does not fit
Fits, after an adapter install
That shaft has no adapter, it is glued into a fixed hosel. A club builder can cut it and install a adapter to make it fit this head.
Fit unknown
We have not verified that model's hosel hardware yet, so we cannot say whether its shaft carries an adapter or is glued in. Treat this combination as unknown rather than assuming a fit.
Not in our catalog
That model is not in our catalog yet. Report it so we can add it, rather than guess.
Shafts that drop in from another head
A shaft pulled from any of these heads carries a sleeve the Exotics E725 Fairway accepts, so it drops straight in, no reshaft.
- Tour Edge Exotics C722 Fairway
- Tour Edge Exotics C723 Fairway
- Tour Edge Exotics C725 Fairway
- Tour Edge Exotics LS Fairway
Stock shafts
- Project X Cypher 2.0 56 g, S flex Project X Cypher 2.0 50, Stiff, is one of two no-upcharge stock shafts on Tour Edge's own E725 Fairway product page, the lighter/higher-launch option.
- Project X Denali Blue 73 g, S flex Project X Denali Blue 70, Stiff, is the other of two no-upcharge stock shafts on Tour Edge's own E725 Fairway product page, the mid-launch/mid-spin option, shared with the C725 Fairway.
Any 0.335 inch tip shaft can be built for this hosel by a club builder; the sleeve, not the shaft model, is what decides whether a used pull drops in.
Shafts from other brands
Sleeve adapters are brand specific. A shaft pulled from a different brand's head carries that brand's sleeve, not this one, so it needs the sleeve swapped by a club builder before it fits this head.
Inferred from aftermarket sleeve part coverage, cross-checked across suppliers.
Thanks. We verify every report against a source before updating the data.
Something went wrong with that report. Please try again.