Manufacturers / Srixon / Z785 Driver / Compatible shafts
Sleeve fitSrixon Z785 Driver compatible shafts
The Z785 Driver uses the Srixon QTS Sleeve adapter (Srixon connector system), QTS Sleeve (Z785 to ZX5 Mk II/ZX5 LS Mk II/ZX7 Mk II, 2018 to 2023) (0.335" tip).
Check your shaft
Type the model your shaft is currently in (or was pulled from) to see whether it fits the Z785 Driver.
Drops straight in
Both use the , " tip. No reshaft, no builder. Re-check your loft position after the swap.
Fits, after an adapter swap
Not a drop-in. This shaft carries a ; the Z785 Driver needs a . The shaft itself works: a club builder swaps the adapter for a small shop fee.
The shaft's " tip differs from this head's " tip, so the builder may need to re-tip it; it may not be a clean swap.
Does not fit
Fits, after an adapter install
That shaft has no adapter, it is glued into a fixed hosel. A club builder can cut it and install a adapter to make it fit this head.
Fit unknown
We have not verified that model's hosel hardware yet, so we cannot say whether its shaft carries an adapter or is glued in. Treat this combination as unknown rather than assuming a fit.
Not in our catalog
That model is not in our catalog yet. Report it so we can add it, rather than guess.
Sleeve interchange
Researched cases where a sleeve from another generation of this same brand does or does not fit this head.
| Sleeve family | Verdict | Notes | Source |
|---|---|---|---|
| Srixon QTS 1.5 Sleeve | Does not fit | Z785 (2018) factory-ships on the original QTS sleeve (this pass's own factory classification), distinct from the 2025 QTS 1.5 sleeve. | Fit from Dunlop Sports Srixon ZXi Woods Hosel Sleeve Adjustability Guide. |
Shafts that drop in from another head
A shaft pulled from any of these heads carries a sleeve the Z785 Driver accepts, so it drops straight in, no reshaft.
- Srixon ZX5 Driver
- Srixon ZX5 LS Mk II Driver
- Srixon ZX5 Mk II Driver
- Srixon ZX7 Driver
- Srixon ZX7 Mk II Driver
Stock shaft
Any 0.335 inch tip shaft can be built for this hosel by a club builder; the sleeve, not the shaft model, is what decides whether a used pull drops in.
Shafts from other brands
Sleeve adapters are brand specific. A shaft pulled from a different brand's head carries that brand's sleeve, not this one, so it needs the sleeve swapped by a club builder before it fits this head.
Fit from Srixon ZX Woods Product Manual (EU).
Adapter settings chart: what every position does
Thanks. We verify every report against a source before updating the data.
Something went wrong with that report. Please try again.